As usual, I'm off into an area I know nothing about.
I'm looking for the wherewithall to make small LaB6 parts. Can anybody
steer me in the right direction? One of the references I found said that
one of the above was required. As a matter of fact, can anybody suggest
where I can find some sort of an "this is all you _really_ need to know"
kind of a book on the subject? Some of the manufacturers of different kinds
of sophisticated equipment generate such books frequently, but I don't know
who they are yet.
I've been designing and building vacuum equipment for years, and have lots
of gear lying around, is it something I could cobble together out of odd
bits? I only need to make a small number of small parts for r&d/proof of
concept stuff, so rude and crude is fine.
I have a modest budget and/or stuff to trade.
Thanks
Rick
Refractal Design, Inc. | voice: 508-777-5500 / fax: 508-777-6575
57 North Putnam St. | Internet: rbecker@refractal.com
Danvers, MA 01923 | Home page: http://www.refractal.com/
USA | "Always remember, most things never
happen."
This archive was generated by hypermail 2b29 : Tue Mar 09 2004 - 07:48:59 EST