Dear colleagues:
We are looking for a working copy of a homespun spin dryer based on a
kitchen blender. The working top is made by machining a recess in the
shape of an inverted cone into a metal disk. The perimeter is shaped as
a small lip to keep the wafer flom flying off. After machining the top
is coated with Teflon.
Any leads just on a good design, and on a service for Teflon coating,
also would be welcome.
Sigurd Wagner
Department of Electrical Engineering
Princeton University
This archive was generated by hypermail 2b29 : Tue Mar 09 2004 - 07:49:01 EST