All,
We are in the process of purchasing some thermocouples to calibrate our diffusion
furnace. We will use either Type S or Type R. I would like to know the most common
diameter of wire used for this calibration. Also, any advice as to the type of wire would
be appreciated. Thanks!
Regards,
Neil Peters
Process Lab Engineer
Department of Chemical and Materials Engineering
http://www.engr.sjsu.edu/cme
San Jose State University voice: (408) 924-3967
One Washington Square fax: (408) 924-4057
San Jose, CA 95192-0082
E-mail: npeters@email.sjsu.edu
-----------------------------------------------------------------------
-----------------------------------------------------------------------
-
You are subscribed to labnetwork@mtl.mit.edu
To unsubscribe from this list, send a message with the message body
"unsubscribe labnetwork" to majordomo@mtl.mit.edu
This archive was generated by hypermail 2b29 : Tue Mar 09 2004 - 07:49:08 EST