[labnetwork] Maxtek MDC-360C
Dennis Culver
djculver at aol.com
Wed Jun 13 16:50:49 EDT 2018
Hello Dave,
Typically I/O issues on older equipment are easy to repair, even without a schematic. Inputs are usually IR coupled devices (photo transistors) and outputs are usually open collector devices. If it's not a specific input or out put, then it would be the device that drives that device. You may also try these folks whom repair equipment that I don't or won't : https://www.fossind.com/
Good Luck!
Dennis J. Culver
Culver Consulting
5960 Valentine Road
Unit 14, Mail box 13
Ventura, CA 93003
Ph (805) 648-1184
Fx (805) 648-1485
Cell(805)680-7389
dennis at culverequipment.com
-----Original Message-----
From: Dave Terry <dave101260 at gmail.com>
To: labnetwork <labnetwork at mtl.mit.edu>
Sent: Wed, Jun 13, 2018 12:50 pm
Subject: [labnetwork] Maxtek MDC-360C
Hello everyone,
I have a Maxtek deposition controller with a bad I/O board.
Does anyone have a contact that supports these products?
In the event that a repair or replacement part is unobtainium, can anyone suggest a replacement unit that will interface easily to a PC?
Thanks,
Best Regards,
------------------------------------
Dave Terry
Dave101260 at gmail.com
Cell: 617 784 7942
-------------------------------------
_______________________________________________
labnetwork mailing list
labnetwork at mtl.mit.edu
https://mtl.mit.edu/mailman/listinfo.cgi/labnetwork
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mtl.mit.edu/pipermail/labnetwork/attachments/20180613/99b7bfb7/attachment.html>
More information about the labnetwork
mailing list