[labnetwork] Software and drivers for K&S 7100-4D Dicing Saw

[Shimon Eliav]

Hi Kevin,

As far as I know K&S became ADT some twenty years ago.

We have good contacts with ADT Israel. We can put you in contact with them.

Some years ago we exchanged the computer and software of our ADT 7100 Dicing system. We kept the old computer just to be in the safe side, but after years of stable operation with the new software/hardware we have no need of it anymore. If you want we can donate it.

Regards,

Shimon

The Hebrew University of Jerusalem

The Unit for Nano Fabrication - UNF

ISRAEL



-----Original Message-----
From: labnetwork [mailto:labnetwork-bounces at mtl.mit.edu] On Behalf Of Kevin M McPeak
Sent: Friday, 12 November 2021 0:46
To: labnetwork at mtl.mit.edu
Subject: [labnetwork] Software and drivers for K&S 7100-4D Dicing Saw



Dear Colleagues,



The LSU nanofabrication facility is getting a K&S 7100-4D Dicing Saw from the DOE equipment donation program. Unfortunately, the DOE is removing the hard drive per their privacy rules. I have reached out to KNS by phone and email but so far I have not had any luck getting a response.



Do you any of you have a good contact at KNS that I could ask about getting software and drivers for this tool? Thanks!



Regards,

Kevin



--

Kevin M. McPeak

Associate Professor | LSU Dept. of Chemical Engineering

225-578-0058 | mcpeaklab.com | lsu.edu/nanofabrication





_______________________________________________

labnetwork mailing list

labnetwork at mtl.mit.edu<mailto:labnetwork at mtl.mit.edu>

https://mtl.mit.edu/mailman/listinfo.cgi/labnetwork
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mtl.mit.edu/pipermail/labnetwork/attachments/20211112/0d44dabb/attachment.html>