[labnetwork] Hot embosser "Drive system disconnected" error

[Greshma Nair]

Hello all,

We have been having some issues with the Jenoptik HEX 02 hot embosser tool. Here are the details:

  1.  After turning on the Emboss software, it prompts to Turn ON the Force control Unit. Pressing the ON button on the panel does not do anything
  2.  A message pops us that reads "Emergency-off-button was pressed or the emergency-loop is open. Please remedy the cause and/or unbolt the Emergency-off button". The EMO button was not pressed
  3.  The message on the Emboss Expert is "Drive system disconnected"

We did get in touch with the tech support in Germany but they haven't been able to troubleshoot the cause yet. From preliminary checks it looks like the EMO loop and the door locks are OK.
Any ideas or suggestions pertaining to this issue will be highly appreciated.

Greshma
--------
Greshma Nair, Ph.D.
Cleanroom Manager
Nanofabrication Facility (NFF)
Center for Advanced Microstructures and Devices (CAMD)
6980 Jefferson Highway
Baton Rouge, LA  70806
Phone: (225) 578-9378
lsu.edu/nanofabrication<http://lsu.edu/nanofabrication>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mtl.mit.edu/pipermail/labnetwork/attachments/20190828/e68fb38d/attachment.html>